B4000 SE Regular Cab 4WD V6-4.0L OHV (1999)
19. Install the LH tie-rod end on the front wheel spindle tie-rod.
1) Rotate the tie-rod end the number of turns recorded during removal.
20. Position the tie-rod ends on the steering knuckles.
Install the castellated nuts and new cotter pins.
1) Check that the brake dust shields are not bent and are not in contact with the outer tie-rod boot seals.
21. tighten the tie-rod end jam nuts.
22. Position the air deflector, and install the retaining screws.
23. Install the front wheel and tire assemblies.
24. Lower the vehicle.
25. Fill, purge and leak check the system.
26. Check and, if necessary, adjust the wheel alignment
