B4000 SE Regular Cab 4WD V6-4.0L OHV (1999)
Band: Adjustments
Band Adjustments
Overdrive/Front Band
Caution:
-
Do not allow overdrive/front band adjustment screw to back out. Band strut could fall out of position.
-
Throw the locknut away. The locknut is not reusable for assembly.
1. Remove and discard the overdrive/front band locknut.
Note: The wrench will click at the specified torque.
2. Tighten overdrive/front band adjustment screw and back off overdrive/front band adjustment screw exactly two (2) turns and hold that position.
Caution:
^
Install, but do not tighten, a new locknut on the band adjustment screw. Apply petroleum jelly to the locknut seal.
^
The front servo must be installed prior to band adjustment.
3. While holding the overdrive/front band adjustment screw stationary, tighten the overdrive/front band locknut using a 19 mm wrench.
4. Install the digital Transmission Range (TR) sensor.