B4000 SE Regular Cab 4WD V6-4.0L OHV (1999)
10. Install the EPC, CCS/SS4, and SS2 solenoids.
Caution: The solenoid clamp must be installed in the TCC and EPC solenoid grooves, shift solenoid pockets and the No. 204 plug.
11. Install the solenoid clamp.
1) Position the solenoid clamp on the main control valve body.
2) Install the solenoid clamp bolts.
12. Connect the TCC, CCS/SS4, SS2, and EPC solenoid electrical connectors.
Caution: Excessive pressure may break the retaining pins.
13. Install the wire loom guide and protector.
^
Align the retaining pins to the holes in the solenoid clamps and gently press in the wire loom guide and protector.
14. Install the oil strainer and a new oil pan gasket.
15. Lower the vehicle.
16. Connect the battery ground cable.
17. Fill transmission to proper fluid level and check for proper transmission operation.
^
Use Mazda ATF TYPE 5 fluid.