B4000 SE Regular Cab 4WD V6-4.0L OHV (1999)
3. Align the manual control lever shaft alignment groove with the manual control lever shaft spring pin bore in the transmission case.
1) Tap the manual control lever shaft spring pin into the transmission case.
4. Align flats of the manual valve inner lever with flats on the manual control lever shaft. Install the manual valve inner lever and parking lever
actuating rod onto the manual control lever shaft.
Caution: Do not bend the manual valve inner lever pin.
5. Install the manual valve inner lever nut.
Caution: Park pawl actuating rod must be properly installed into parking pawl and guide cup located in extension housing. Verify park linkage
function.
6. Verify that the output shaft is locked in the PARK position.
7. Install the transmission fluid pan with new pan gasket.
8. Install the digital TR sensor.
9. Lower the vehicle.
10. Connect the battery ground cable.
11. Fill the transmission to the proper fluid level.
