B4000 SE Regular Cab 4WD V6-4.0L OHV (1999)
9. Remove the EPC and SS2 solenoids.
1) Remove the solenoid clamp bolts.
2) Remove the solenoid clamp.
3) Remove the EPC and SS2 solenoids.
Caution: Do not pry on the other wires or damage the connector case surface.
10. Disconnect the Turbine Shaft Speed (TSS) sensor electrical connector from the transmission case (16 pin) electrical connector.
1) Disconnect the TSS sensor electrical connector.
2) Remove from the TSS sensor wire locator.
Caution: Do not overstretch the retaining spring.
11. Remove the transmission case (16 pin) electrical connector retaining spring.
Caution: Do not damage the connector or harness
12. Remove the transmission case (16 pin) electrical connector.
1) Compress the tabs on the transmission case (16 pin) electrical connector.
