B Series Truck 2WD L4-2184cc 2.2L 2200 2-bbl (1990)
2. Remove the bearing and bearing housing assembly with the SST.
Caution: Secure the rear axle shaft in a vise in which copper plates are used.
3. After removing the bearing and oil seal from the rear wheel hub, tap lightly with a suitable round bar to force out the outer race.
INSPECTION
Inspect for the following problems, and replace any faulty pans.
1. Wear, damage, and seizure of bearing
Caution:
(a) If the bearing is replaced, be sure to adjust the bearing play in the axial direction.
(b) Replace the bearing inner and outer races as a set.
2. Cracks and damage on wheel hub
3. Bends and cracks on axle shaft
ASSEMBLY
1. Press fit the new oil seal with the SST.
2. Press fit the bearing inner race with the SST.
3. Liberally coat with lithium based grease the places indicated by oblique lines in the figure.