B Series Truck 2WD L4-2184cc 2.2L 2200 2-bbl (1990)
4. Using the SST, tap the new oil seal in until it is flush with the end of the axle casing.
5. Coat the oil seal lip with lithium based grease.
6. Install the spacer on the axle shaft.
7. Using the SST and a press, press the wheel bearing onto the axle shaft.
Standard press-fit force: 4,200-6,100 kg (30,379-44,121 lb)
Caution: If the press-fit force is too high or too low, replace the bearing collar or shaft.
8. Remove the bearing installer, and attach the bearing locknut to the axle shaft.
9. Using the SST to tighten the bearing locknut, and press in the bearing.
10. Remove the rear shaft bearing nut wrench, and install a new lock washer so that its tab fits into the groove of the rear axle shaft.
11. Tighten the bearing locknut to the specified torque.
Tightening torque: 196-294 Nm (20-30 m-kg, 145-217 ft-lb)
Caution: The torque wrench must be attached perpendicular to the rear shaft bearing nut wrench (49 0603 635A).
