B Series Truck 4WD L4-2606cc 2.6L SOHC (1992)
Throttle Full Close Switch: Testing and Inspection
Idle Switch Inspection
1. Disconnect idle switch connector.
2. Check continuity between switch and ground. There should be continuity with throttle valve fully closed and no continuity with throttle open.
3. If not as specified, check condition of idle switch wiring harness. If idle switch is determined defective, throttle body and switch must be replaced
as a unit.
Idle switch input signal can be checked at ECU terminal 1N with ignition "ON." With accelerator pedal released, terminal voltage should be 0V. With
pedal depressed, voltage should be approximately 12V.
