CX-7 AWD L4-2.3L Turbo (2008)
4. Wrap the tip of a small flat screwdriver with vinyl tape (A), and use it to lift up the 3 battery terminals (B) on the circuit board approximately 30
degrees to the plane.
NOTE:
In order to achieve enough pretension, it is necessary to bend the terminals approximately 30 degrees.
CAUTION:
Be careful not to damage any element and/or printed pattern on the circuit board. Also, avoid bending the terminals too much as this may break it.
5. Reinstall the battery in the transmitter. Refer to MS3 online instructions or Workshop Manual section 09-14 TRANSMITTER BATTERY
REPLACEMENT [WITH KEYLESS ENTRY SYSTEM].
A: Upper side (+)
B: Bottom side (-)
NOTE:
