CX-7 AWD L4-2.3L Turbo (2008)
Cross-Member: Service and Repair
Front Crossmember Removal/Installation
FRONT CROSSMEMBER REMOVAL/INSTALLATION
1. Remove the side cover and under cover.
2. Drain the power steering fluid.
3. Remove the transverse member.
4. Remove the intermediate shaft installation bolt, and disconnect the steering shaft.
5. Remove in the order indicated in the table.
6. Install in the reverse order of removal.
7. When replace the front crossmember, inspect the front wheel alignment and adjust it if necessary
Tie-rod End Ball Joint Removal Note