CX-7 AWD L4-2.3L Turbo (2008)
2. Using a jumper wire, short fuel pump relay terminals C and D in the main fuse block.
3. Connect the negative battery cable and operate the fuel pump.
9. Turn the ignition switch to the LOCK position.
10. Measure the fuel pump hold pressure after 5 min.
-
If not as specified, replace the fuel pump after inspecting the following:
-
Fuel line for clogging or leakage
Fuel pump hold pressure
More than 230 kPa (2.3 kgf/sq.cm, 33 psi)
11. Disconnect the jumper wire.
12. Disconnect the SST.
13. Connect the quick release connector.
