CX-7 AWD L4-2.3L Turbo (2008)
12.
Shake a bottle of the Mazda Air Cooling Coil Coating well and attach it to the applicator, then connect the applicator to compressed shop air.
13.
Insert the applicator inside the hole. Point the nozzle tip in direction of the evaporator.
14.
Begin spraying by gently moving the nozzle tip back and forth from the top to the bottom to evenly coat the evaporator.
15.
When the bottle is empty, remove the applicator.
NOTE:
For reuse, clean the applicator by flushing a bottle of clean water through it.
16.
Reinstall the cabin air filters, then the cabin air filter cover.
17.
Connect the Power MOS FET connector.
18.
Connect the evaporator temperature sensor connector.
19.
Reinstall the metal bracket.
20.
Reinstall the PJB and PJB bracket. Refer to appropriate Workshop Manual section 09-40 - PASSENGER JUNCTION BOX (PJB)
REMOVAL/INSTALLATION.
21.
Reinstall the console side wall.
22.
Use STEP 1 to dry and cure product.
23.
Note application date in service record.
1998-2003 Protege & Protege5
1998-2003 Protege & Protege5
1.
Dry the evaporator using the following procedure:
WARNING:
Running the engine inside an enclosed area, such as a garage, is dangerous. Exhaust gas, which contains poisonous carbon monoxide, could
easily enter the cabin. Loss of consciousness or even death could occur. Don't run the engine when inside an enclosed area.
A.
Start the engine.
