CX-7 AWD L4-2.3L Turbo (2008)
B.
Set the HVAC controls as follows.
^
RECIRCULATE
^
FULL HEAT
^
FAN HIGH
^
A/C OFF
^
AIRFLOW (FACE)
C.
Open one window approximately one half inch.
D.
Let the engine run for 15 minutes.
2.
Remove the glove box by:
A.
Pushing the top stops inward (plastic will flex).
B.
At the left side hinge, lift the clip out of its seat.
C.
Pull the right axle pin out towards the left side and remove the glove box.
3.
Stop the engine. Switch OFF the fan motor.
4.
Remove the fan resistor and inspect the evaporator for debris; remove debris using an appropriate vacuum cleaner.
WARNING:
Blower motor resistor may be extremely hot.
