CX-7 AWD L4-2.3L Turbo (2008)
^
Heater control: full heat
^
Fan: high
^
A/C switch: off
^
Airflow (Face)
C.
Open one window approximately one half inch.
D.
Let the engine run for 15 minutes.
2.
Remove the glove box by:
A.
Remove the dumper clip.
B.
Bend the stoppers inward, then remove.
C.
Turn the glove compartment downward and pull the pins.
3.
Shake a bottle of Mazda Cooling Coil Coating well and attach it to the applicator, then connect the applicator to compressed shop air.
4.
Insert the applicator in the grille of the the recirculation door. Point the nozzle tip downwards and towards center (approximately the 7 o'clock
position).
5.
Spray the entire contents of the bottle in short bursts, 3 seconds ON, 3 seconds OFF into the rotating fan. A fine mist may exit from the ducts.
6.
When the bottle is empty, stop the engine and remove the applicator.
NOTE:
Clean the empty bottle by flushing it with clean water.
7.
Use STEP 1 to dry and cure the product.
8.
While the product is drying, re-install the glove box.
