CX-7 AWD L4-2.3L Turbo (2008)
2.
Remove the lower panel by pulling downward at both ends.
3.
Remove the 10 mm nut retaining the cabin air filter bracket.
4.
Remove the bracket by sliding downward.
5.
Remove the cabin air filters by sliding downward. Discard the filters if dirty.
6.
Cover the cabin air filter access hole with duct tape.
7.
Pierce a hole in the center of the duct tape with a knife.
8.
Shake a bottle of Mazda Cooling Coil Coating well and attach it to applicator, then connect the applicator to compressed shop air.
9.
Insert the applicator into the pierced hole through the duct tape.
10.
Point the nozzle tip in the direction of the driver's side.
11.
Spray the entire contents of the bottle in short bursts, 3 seconds ON, 3 seconds OFF into the rotating fan. A fine mist may exit from the ducts.
12.
When the bottle is empty, stop the engine and remove the applicator.
