CX-7 AWD L4-2.3L Turbo (2008)
51.
Insert 2nd key and turn to ON position (do not start engine) for 3 seconds. PATS light remains OFF. This is normal. Start engine. Turn key OFF
and remove.
52.
Insert 1st key and turn to ON position. Confirm PATS light stays ON 3 seconds and then goes out. Start engine. Turn key OFF and remove. 2 keys
are now programmed. Confirm PATS light blinks. If additional keys need programming, use the "Two Valid Key Program Method" in the next
step. Otherwise, go to "COMPLETING PROCEDURE".
53.
Insert 1st valid (programmed) key and then turn to ON position (do not start engine) until PATS light proves out.
54.
Insert 2nd valid (programmed) key and then turn to ON position (do not start engine) until PATS light proves out.
55.
Insert 1st spare (unprogrammed) key and turn ON (do not start engine) until PATS light proves out.
56.
If there are additional spare keys, repeat previous step for each key.
57.
If there are no additional spare keys, start engine with ALL keys to ensure programming is successful.
58.
Confirm all spare keys can start engine.
COMPLETING PROCEDURE
59.
Reconnect DLC to vehicle. Press tick.
60.
Select "EXIT (From this menu)". Press tick.
61.
Screen shows "Operation Action" screen.
62.
Turn ignition switch ON, then press tick.
63.
Screen shows "Select Option". Select "IGNITION KEY CODE ERASE and PROGRAM". Press tick.
64.
Press tick again (to return to Vehicle Specification screen).
65.
The configuration procedure is now completed.
Part 1
MODELS WITH ADVANCED KEYLESS SYSTEM
NOTE:
^
The following procedures are written for MMDS-IDS only. MMDS-PDS will be similar.
^
PDS does not support Module Configuration Programming (MCP) on all models. It is recommended to use IDS when performing this
procedure.
^
If IDS/PDS cannot retrieve configuration data from the old odometer, a screen will automatically appear that requires As-built data.
However, configuration using the As-Built data cannot transfer old odometer data to a new odometer.
^
Before starting, make sure you have all customer advance (card) keys with auxiliary (ignition) keys installed since they will need to be
reprogrammed to start the vehicle. A minimum of two card and two ignition keys are required to start vehicle.
1.
Connect IDS to the vehicle.
2.
Select IDS icon (from desktop).
3.
Select "START NEW SESSION". Press tick (check mark box located at lower right of screen).
4.
Turn ignition switch ON (do not start engine).
5.
Press tick. IDS now establishes communication to PCM.
6.
"Vehicle specifications" will be shown. Select YES.
7.
Screen will display "Is vehicle equipped with DSC?" Select YES or NO depending on vehicle then press tick.
