CX-7 AWD L4-2.3L Turbo (2008)
29.
Screen displays "Close all vehicle doors. Set ignition switch to ON (Position II)". Press tick.
30.
Screen displays "Does this vehicle have the SKE system?" Select "YES" (vehicle is equipped with the SKE (Advanced Keyless Entry) system).
31.
Select "PARAMETER RESET" from the list of choices. Press tick.
32.
You will be asked "Did you replace HEC?" Select YES.
33.
Screen shows "Gaining Security Access". Read the information then select "YES" at the bottom of the screen to continue.
34.
Screen now displays the VIN. Verify the VIN information then select "YES" at the bottom of the screen to continue.
35.
Screen now displays the VIN, Part Number, Serial Number, Outcodes and Error Control. Record the Part Number, Serial Number, Outcodes and
Error Control information. These numbers will be used to obtain Incodes from the Mazda Service Support (MS3) system web site.
Part 2
36.
Obtain Incodes through MS3, one for HEC, one for SKE and one for PCM. On the MS3 home page select "OTHER APPLICATIONS", then
"PATS". Fill out the required information and click "Submit".
37.
After obtaining Incodes, select "YES" on IDS screen to continue.
38.
Enter Incodes, then press tick.
39.
Screen shows "Security Access Granted". Press tick.
40.
Title of next screen shows "PARAMETER RESET" and the following information is displayed:
WARNING!
-
You will need two keys to start the vehicle if you have replaced the PATS, IC, VIC, HEC or RKE module.
-
Do you wish to continue?
Select YES. Screen will now reset security ID.
41.
Screen shows Blue status bar. When status bar reaches 100% "This operation has been successful" is displayed.
Press tick.
42.
Screen displays "Operation Successful". Press tick.
43.
Screen displays "Which module have you replaced?" Select "IC", then press tick.
44.
Screen displays "Module reset is now complete". Press tick.
NOTE:
At this time, the ignition keys (auxiliary keys) will need to be reprogrammed.
46.
Screen title displays "PATS FUNCTIONS". Select "IGNITION KEY CODE ERASE and PROGRAM". Press tick.
46.
Next screen warns you to make sure you have TWO (2) keys. Select YES to continue. Ignition key codes will now be erased.
47.
Screen shows Blue status bar. When status bar reaches 100% "This operation has been successful" is displayed. Press tick.
48.
Screen displays "All known keys have been erased. You must now program a minimum of two keys". Press tick.
49.
Screen title shows "Keyless and PATS Functions".
50.
Turn ignition switch OFF.
51.
Remove start knob from ignition switch. Remove both ignition (auxiliary) keys from Advanced Keys to prepare for programming.
52.
Insert first ignition key and turn to ON position (do not start engine). Count to 4 seconds, turn key OFF and remove key from ignition.
NOTE:
