CX-7 AWD L4-2.3L Turbo (2008)
1. Connect the M-MDS to the DLC-2.
2. Using the simulation function "FP", start the fuel pump.
Without using M-MDS
1. Remove the fuel pump relay.
CAUTION: Short the specified terminals because shorting the wrong terminal of the main fuse block may cause malfunctions.
2. Using a jumper wire, short fuel pump relay terminals C and D in the main fuse block.
3. Connect the negative battery cable and operate the fuel pump.
CAUTION: The fuel pump could be damaged if it is operated (fuel pump idling) while there is no fuel in the fuel tank. Verify the
amount of fuel being discharged from the hose and stop operation of the fuel pump when essentially no fuel is being discharged.
7. When essentially no fuel is being discharged, stop the fuel pump.
Using M-MDS
1. Using the simulation function "FP", stop the fuel pump.
Without using M-MDS
1. Turn the ignition switch to LOCK position to stop the fuel pump.
2. Disconnect the jumper wire from the check connector.
8. Disconnect the negative battery cable.
9. Remove in the order indicated in the table.
10. Install in the reverse order of removal.
11. Complete the "AFTER REPAIR PROCEDURE".