CX-7 AWD L4-2.3L Turbo (2008)
Fluid - A/T: Procedures
AUTOMATIC TRANSAXLE FLUID (ATF) INSPECTION [AW6A-EL, AW6AX-EL]
Automatic Transaxle Fluid (ATF) Condition Inspection
1. Inspect the ATF for the following to determine whether the transaxle should be disassembled.
^
The ATF is muddy.
^
The ATF smells strange or unusual.
ATF Condition
ATF Condition
Automatic Transaxle Fluid (ATF) Level Inspection
Caution
The ATF amount varies according to ATF temperature. Therefore, when checking the ATF level or replacing the ATF, use a thermometer to
measure the temperature and adjust the ATF amount to the specified level according to the specified temperature.
1. Place the vehicle on level ground.
2. Apply the parking brake and position wheel chocks securely to prevent the vehicle from rolling.
3. Adjust the length or thermometer probe so that the length is the same as the depth gauge, and hold the probe with a paper holder. Insert into the
filler tube and measure the temperature. If necessary, inspect the ATF before warming up the engine. In this case, use the ATF temperature (15-25
°C (59-77°F)).
4. Warm up the engine until the ATF reaches 60-70°C (140-158°F).
5. Shift the selector lever and pause momentarily in each range (P-D) while depressing the brake pedal.
6. Shift the selector lever to P position.
