CX-7 AWD L4-2.3L Turbo (2008)
Engine Control Module: Procedures
PCM CONFIGURATION[L3 WITH TC]
1. Connect the M-MDS to DLC-2.
2. After the vehicle is identified, select the following items from the initial screen of the M-MDS.
-
When using the IDS (notebook PC)
1. Select the "Module Programming".
-
When using the PDS (pocket PC)
1. Select "Programming".
2. Select "Module Programming".
3. Then, select the "Programmable Module Installation", "PCM" from the screen menu.
NOTE: If the PCM is replaced with a new one, the PCM stores DTC P0602, illuminates the MIL even though no malfunction is detected. When
the configuration is completed, DTC P0602 is cleared.
4. Retrieve DTC's using the M-MDS, then verify that DTC are present.
-
If a DTC is present, perform the applicable DTC inspection.