CX-7 AWD L4-2.3L Turbo (2008)
2. Spray CRC Freeze-Off (or equivalent) around flange area of oxygen sensor.
CAUTION:
Avoid excess spraying. Remaining flammable substance could catch fire.
3. Allow lubricant to reach sensor threads for a minimum of 1 - 2 minutes.
NOTE:
FOLLOW ALL PENETRANT MANUFACTURER INSTRUCTIONS LISTED ON THE PRODUCT LABEL.
4. Turn 30 degrees counter-clockwise with SST (49 L018 001).
5. Remove SST and spray lubricant again in the same place.
6. Allow lubricant to reach sensor threads for a minimum of 1 - 2 minutes.
7. Use SST to loosen sensor.
NOTE:
If sensor begins to bind, it may be necessary to work the sensor in a tightening and loosening motion to slowly work the sensor out.
8. Wipe off all excess lubricant.
