CX-7 AWD L4-2.3L Turbo (2008)
Engine Control Module: Removal and Replacement
PCM REMOVAL/INSTALLATION[L3 WITH TC]
NOTE: For PCM replacement, set up the M-MDS and perform the PCM configuration. (See PCM CONFIGURATION[L3 WITH IC].)
1. Disconnect the negative battery cable.
2. Remove the charge air cooler duct.
3. Remove the Battery and battery tray
4. Remove the mudguard (LH).
5. Remove in the order indicated in the table.
6. When replacing the PCM on the vehicles, perform the following.
-
PCM parameter reset (See IMMOBILIZER SYSTEM COMPONENT REPLACEMENT/KEY ADDITION AND CLEARING[ADVANCED
KEYLESS SYSTEM].) (See IMMOBILIZER SYSTEM COMPONENT REPLACEMENT/KEY ADDITION AND CLEARING[KEYLESS
ENTRY SYSTEM].)
7. Install in the reverse order of removal.
