CX-7 AWD L4-2.3L Turbo (2008)
Intake Air Temperature Sensor: Testing and Inspection
Boost Air Temperature Sensor Inspection
BOOST AIR TEMPERATURE SENSOR INSPECTION [L3 WITH TC]
Resistance Inspection
NOTE: Before performing the following inspection, make sure to follow the procedure as indicated in the troubleshooting flowchart. (See HOW TO
USE THIS MANUAL.)
1. Disconnect MAP/boost air temperature sensor.
Specification
2. Measure the resistance between the MAP/boost air temperature sensor terminals A and B using a tester.
-
If not as specified, replace the MAP/boost air temperature sensor.
-
If the MAP/boost air temperature sensor is normal, but PID are out of specification, perform the "Circuit Open/Short Inspection".
Circuit Open/Short Inspection
Circuit Open/Short Inspection
1. Disconnect the PCM connector.