CX-7 AWD L4-2.3L Turbo (2008)
Intake Air Temperature Sensor: Testing and Inspection
Intake Air Temperature (IAT) Sensor Inspection
INTAKE AIR TEMPERATURE (IAT) SENSOR INSPECTION[L3 WITH TC]
Resistance Inspection
NOTE: Before performing the following inspection, make sure to follow the procedure as indicated in the troubleshooting flowchart. (See HOW TO
USE THIS MANUAL.)
1. Disconnect the MAF/IAT sensor.
Specification
2. Measure the resistance between the MAF/IAT sensor terminals D and E using a tester.
-
If not as specified, replace the MAF/IAT sensor.
-
If the MAF/IAT sensor is normal, but the PID is out of specification, perform the "Circuit Open/Short Inspection".
Circuit Open/Short Inspection
1. Disconnect the PCM connector.
2. Inspect the following wiring harnesses for an open or short circuit. (Continuity check)