CX-7 AWD L4-2.3L Turbo (2008)
Vehicle Speed Sensor: Testing and Inspection
Vehicle Speed Sensor (VSS) Inspection [AW6A-EL, AW6AX-EL]
VEHICLE SPEED SENSOR (VSS) INSPECTION [AW6A-EL, AW6AX-EL]
On-Vehicle Inspection
Caution:
^
Water or foreign material entering the connector can cause a poor connection or corrosion. Be sure not to allow water or foreign
material on the connector when disconnecting.
^
Do not damage the terminals.
1. Disconnect the negative battery cable.
2. Remove the air cleaner component.
3. Remove the TCM.
4. Verify that there is no continuity between the coupler component terminals 1319 and GND or B20 and GND.
^
If there is any malfunction, inspect the coupler component.
^
If the coupler component is normal, replace the ATX.
Note:
^
Inspect with a tester that can indicate more than 10 megohms and confirm that the value is more than 1 megohm.
5. Verify that there is continuity between coupler component terminals 1319 and B20.
^
If there is any malfunction, inspect the coupler component.
^
If the coupler component is normal, replace the ATX.
6. Install the TCM.
7. Install the air cleaner component.
8. Connect the negative battery cable.
Off-Vehicle Inspection
Warning:
^
A hot transaxle and ATF can cause severe burns. Turn off the engine and wait until they are cool before replacing the ATF.
Caution:
^
Water or foreign material entering the connector can cause a poor connection or corrosion. Be sure not to allow water or foreign
material on the connector when disconnecting.
^
Do not damage the terminals.
