CX-7 AWD L4-2.3L Turbo (2008)
^
If there is any malfunction, inspect the coupler component.
^
If the coupler component is normal, replace the ATX.
6. Install the TCM.
7. Install the air cleaner component.
8. Connect the negative battery cable.
Off-Vehicle Inspection
Warning
^
A hot transaxle and ATF can cause severe burns. Turn off the engine and wait until they are cool before replacing the ATF.
Caution
^
Water or foreign material entering the connector can cause a poor connection or corrosion. Be sure not to allow water or foreign
material on the connector when disconnecting.
^
Do not damage the terminals.
1. Disconnect the negative battery cable.
2. Remove the VSS.
3. Connect the VSS terminal 2 to the battery positive terminal, connect the battery negative terminal to VSS terminal 1 through an ammeter set to a
resistance of 100 ohm.