CX-7 AWD L4-2.3L Turbo (2008)
t.
Insert the Red wire of the load reduction relay harness through the eyelet made in the Red wire (terminal 2 of the 10-pin connector) of the
remote start harness.
u.
Twist the Red wire of the load reduction relay harness around the Red wire of the remote start harness.
v.
Solder the Red wire of the load reduction relay harness to the Red wire of the remote start harness. Insulate the connection with electrical
tape and ensure no bare wires are exposed.
7.
Carefully insert the Blue/Black wire with terminal from the load reduction relay harness into terminal 10 (currently empty) of the remote start
10-pin harness connector.
8.
Reinstall the secondary lock into the 10-pin harness connector.
9.
Install the remote engine start module and load reduction relay harness.
a.
Plug all disconnected connectors into the remote engine start module.
