CX-7 AWD L4-2.3L Turbo (2008)
b.
Locate the large factory wire harness high up under the dashboard - running near the vehicle dash wall as shown.
c.
Using (3) supplied, long tie straps, secure the remote start control module to the large factory harness.
d.
Route the load reduction relay harness upward and secure to the large factory harness with (3) supplied, long tie straps.
10.
Power-up the system.
a.
Verify that all connections are secure.
b.
Turn the ignition switch to RUN position.
c.
Reconnect the negative battery cable.
d.
Turn the ignition switch to the OFF position.
11.
Perform a functional test of the remote engine start system.
a.
Ensure the key is removed from the ignition switch and the hood is closed. Press the start button on the remote engine start transmitter twice
within 3 seconds. The parking lights should flash one time, the horn should beep once, then the vehicle should crank and start. Once started,
the parking lights will turn on and stay on signifying the vehicle is running.
b.
Check the HVAC system to ensure heat and A/C is on and moving air. Adjust fan speed to high, if necessary.
c.
Start vehicle with ignition key to ensure proper vehicle operation.
