CX-7 AWD L4-2.3L Turbo (2008)
7. Slowly remove the brake piston from the servo cover.
8. Remove O-rings from the brake piston and the servo cover, apply ATF to the new O-rings, and assemble them into the servo cover and the brake
piston. Install the piston spring.
^ Be careful not to damage new O-rings during the assembly.
9. Use a stand lift to press the servo cover, the brake piston and the spring into position.
^ Turn servo cover during installation to prevent O-ring damage.
^ Press in the servo cover 1mm above the snap ring groove.
