CX-7 AWD L4-2.3L Turbo (2008)
Valve Body: Removal and Replacement
CONTROL VALVE BODY REMOVAL/INSTALLATION [AW6A-EL, AW6AX-EL]
On-Vehicle Removal
Warning
^
Using compressed air can cause dirt and other particles to fly out, causing injury to the eyes. Wear protective eyeglasses whenever using
compressed air.
Caution
^
Clean the transaxle exterior throughout with a steam cleaner or cleaning solvents before removal.
^
If any old sealant gets into the transaxle during installation of the control valve body cover, trouble may occur in the transaxle case and
control valve body cover. Clean with cleaning fluid.
1. Disconnect the negative battery cable.
2. Remove the air cleaner component.
3. Remove the under cover.
4. Drain the ATF.
5. Remove the resonance chamber.
6. Remove the thermo valve.
7. Remove the control valve body cover installation bolt.
Caution
^
Do not damage the fitting surface of the transaxle case and the control valve body cover.
^
Do not deform the control valve body cover.
