CX-7 AWD L4-2.3L Turbo (2008)
Over-Run Clutch Assembly: Removal and Replacement
COUPLING COMPONENT REMOVAL/INSTALLATION
1. Drain the rear differential oil into a container.
2. Remove the main silencer and middle pipe.
3. Remove the propeller shaft.
4. Remove in the order indicated in the table.
5. Install in the reverse order of removal.
6. Add rear differential oil.
Coupling Component Removal Note
1. Support the coupling unit with a transmission jack.
2. Cut away the coupling unit using an oil pan seal cutter.
Coupling Component Installation Note
Note:
^
Clean away the old sealant before applying the new sealant.
^
Install the coupling unit within 10 min after applying sealant.
^
Allow the sealant to set at least 30 min after installation before filling the differential with the specified oil.
