CX-7 FWD L4-2.3L Turbo (2010)
Antenna Cable: Testing and Inspection
Antenna Feeder No.2 Inspection
ANTENNA FEEDER NO.2 INSPECTION
1. Disconnect the negative battery cable.
2. Remove the following parts:
a. A-pillar lower trim (RH) See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair/A-Pillar Lower Trim
Removal/Installation
b. A-pillar trim (RH) See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair/A-Pillar Trim Removal/Installation
c. Rear scuff plate inner (RH) See: Body and Frame/Interior Moulding / Trim/Scuff Plate/Service and Repair/Rear Scuff Plate
Removal/Installation
d. Rear seat See: Body and Frame/Seats/Service and Repair/Removal and Replacement/Rear Seat Removal/Installation
e. Sub trunk box See: Body and Frame/Doors, Hood and Trunk/Trunk / Liftgate/Trunk / Liftgate Interior Trim Panel/Service and Repair
f.
Trunk end trim See: Body and Frame/Interior Moulding / Trim/Scuff Plate/Service and Repair/Trunk End Trim Removal/Installation
g. Trunk side trim (RH)
h. D-pillar trim (RH) See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair/D-Pillar Trim Removal/Installation
3. Disconnect the antenna feeder No.1.
4. Disconnect the antenna feeder No.3.
5. Verify that the continuity between antenna feeder No.2 terminals is as indicated in the table.
