CX-7 FWD L4-2.3L Turbo (2010)
CAUTION:
-
If the speaker is installed with the wiring harness out of the groove, an open circuit in the wiring harness could occur.
Rear Speaker Removal/Installation
REAR SPEAKER REMOVAL/INSTALLATION
1. Disconnect the negative battery cable.
2. Remove the following parts:
a. Rear scuff plate inner See: Body and Frame/Interior Moulding / Trim/Scuff Plate/Service and Repair/Rear Scuff Plate Removal/Installation
b. Rear seat See: Body and Frame/Seats/Service and Repair/Removal and Replacement/Rear Seat Removal/Installation
c. Sub trunk box See: Body and Frame/Doors, Hood and Trunk/Trunk / Liftgate/Trunk / Liftgate Interior Trim Panel/Service and Repair
d. Trunk end trim See: Body and Frame/Interior Moulding / Trim/Scuff Plate/Service and Repair/Trunk End Trim Removal/Installation
e. Trunk side trim
f.
D-pillar trim See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair/D-Pillar Trim Removal/Installation
3. Remove in the order indicated in the table.
4. Install in the reverse order of removal.