CX-7 FWD L4-2.3L Turbo (2010)
Body Control Module: Component Tests and General Diagnostics
BODY CONTROL MODULE (BCM) INSPECTION
1. Disconnect the negative battery cable.
2. Remove the following parts:
-
Front scuff plate. (driver-side) See: Interior Moulding / Trim/Scuff Plate/Service and Repair/Front Scuff Plate Removal/Installation
-
Front side trim. (driver-side) See: Interior Moulding / Trim/Trim Panel/Service and Repair/Front Side Trim Removal/Installation
-
Console panel. See: Interior Moulding / Trim/Console/Service and Repair/Removal and Replacement/Console Panel Removal/Installation
-
Console See: Interior Moulding / Trim/Console/Service and Repair/Removal and Replacement/Console Removal/Installation
3. Set the hood release lever out of the way. See: Doors, Hood and Trunk/Hood/Hood Latch Release/Service and Repair
4. Remove the lower panel. See: Interior Moulding / Trim/Dashboard / Instrument Panel/Service and Repair/Removal and Replacement/Lower Panel
Removal/Installation
5. Remove the BCM with the connector connected. See: Service and Repair
6. Connect the negative battery cable.
7. Measure the voltage at each terminal is as indicated in the Terminal Voltage Tables.
-
If the voltage is not as specified in the Terminal Voltage Table, inspect the parts under "Inspection item (s)".
-
If the system does not work properly even though the parts or related wiring harnesses do not have any malfunction, replace the BCM.
Terminal Voltage Table (Reference)
