CX-7 FWD L4-2.3L Turbo (2010)
Rear Door Window Regulator: Service and Repair
REAR POWER WINDOW REGULATOR REMOVAL/INSTALLATION
1. Fully lower the rear door glass.
2. Remove the following parts:
a. Rear beltline molding (See )
b. Sail garnish (See See: Interior Moulding / Trim/Trim Panel/Service and Repair/Sail Garnish Removal/Installation)
c. Rear door garnish (See )
3. To access the glass installation bolt, position the rear door glass so that the distance from the top of the rear door glass to the upper part of the rear
beltline molding is approx. 140 mm {5.5 in}.
4. Disconnect the negative battery cable.
5. Rear door trim (See See: Rear Door Panel/Service and Repair/Removal and Replacement)
6. Remove the rear door speaker. (See See: Accessories and Optional Equipment/Radio, Stereo, and Compact Disc/Speaker/Service and Repair/Rear
Door Speaker Removal/Installation)
7. Remove the rear door glass. (See See: Rear Door Window Glass/Service and Repair)
8. Remove the rear power window motor. (See See: Front Door/Front Door Window Motor/Service and Repair)
9. Remove the nuts.
10. Insert a hand through the speaker installation hole, rotate the drum housing in the direction shown in the figure to detach the tabs from the rear
door unit.
11. Remove the rear power window regulator through the speaker installation hole.
