CX-7 FWD L4-2.3L Turbo (2010)
6. Remove the air duct (A).
a. Disconnect the purge solenoid valve connector.
b. Disconnect the EGR valve connector.
c. Move ATF gauge pipe (B) out of the way.
7. Loosen the bolts of the water pipe (A) brackets (B and C).
8. Remove the under cover and right side splash shield
9. Drain the engine oil into a container.
10. Install the oil pan drain plug with a new washer.
Tightening Torque: 30-41 N.m (3.1-4.1 kgf-m, 23-30 ft-lb)
11. Before loosening the bolts securing the engine and transmission, put a mark on each transaxle bolt and the transaxle (so you can determine when they
have been turned one full turn), then loosen the bolts one full turn (360 degrees).
NOTE:
