CX-7 FWD L4-2.3L Turbo (2010)
2. Using a scraper or a similar tool, completely remove the gasket residue from the joint of cylinder block, front cover and oil pan.
NOTE:
Do not allow the gasket residue to enter the oil pan. Using cleaning fluid, completely remove the oil from the joint. Especially be sure to completely
remove oil and gasket residue from the corner section of the front cover and the cylinder block.
Recommended Cleaner:
- Mazda Brake Parts Cleaner (low VOC, non-chlorinated) P/N 000-77-620E-05 or equivalent.
3. Completely clean and remove any oil, dirt, sealant or other foreign material that may be adhering to the housing and oil pan.
CAUTION:
When reusing oil pan installation bolts, clean any old sealant from the bolts. Using bolts with the old seal adhering could cause cracks in the housing.
4. Apply silicone sealant to the oil pan in a single, unbroken line around the whole perimeter of the oil pan as shown in the following illustrations.
NOTE:
Install the oil pan within 10 minutes after applying the silicone sealant, otherwise the gasket material will get too hard and you will have to scrape the oil
