CX-7 FWD L4-2.3L Turbo (2010)
b. Install the left rear shaft of the SST to the bolt of the left shock absorber. (Identical position to the right side)
c. Temporarily tighten the bolt (M6 x 1.0) to the air cleaner bracket installation position and install front foot No. 2 to the left/right front shaft of
the SST, and align the front shaft hole of the SST with the bolt as shown in the figure.
d. Adjust the positions of the SST side bars so that they are the same height (left and right) and horizontal.
e. Make sure each joint is securely tightened.
6. Support the engine using the SST.
Front Oil Seal Removal Note
1. Remove the front oil seal using a flathead screwdriver or similar tool.
Chain Tensioner Removal Note
