CX-7 FWD L4-2.3L Turbo (2010)
33. Fix the exhaust camshaft using a wrench on the cast hexagon, and tighten the sprocket bolt.
Tightening torque
-
69-75 Nm {7.1-7.6 kgf-m, 51-55 ft-lbf}
34. Remove the SST from the camshaft.
35. Remove the SST installed in the cylinder block lower blind plug hole.
36. Rotate the crankshaft clockwise two turns and inspect the valve timing.
-
If not aligned, loosen the camshaft sprocket bolt and repeat the procedure from Step 30.
37. Apply the silicone sealant and install the engine front cover upper blind plug.
Tightening torque
-
8.0-11.5 Nm {82-117 kgf-cm, 71-101 in-lbf}
38. Install the cylinder block lower blind plug.
Tightening torque
-
18-22 Nm {1.9-2.2 kgf-m, 14-16 ft-lbf}
39. Install a new engine front cover lower blind plug.
