CX-7 FWD L4-2.3L Turbo (2010)
Refrigerant Pressure Sensor / Switch: Service and Repair
Refrigerant Pressure Sensor Removal/Installation - Full-Auto Air Conditioner
REFRIGERANT PRESSURE SENSOR REMOVAL/INSTALLATION [FULL-AUTO AIR CONDITIONER]
1. Disconnect the negative battery cable.
2. Discharge the refrigerant from the system. See: Service and Repair/Refrigerant Recovery See: Service and Repair/Refrigerant Charging
3. Loosen the refrigerant pressure sensor using two spanners.
4. Remove in the order indicated in the table.
5. Install in the reverse order of removal.
6. Perform the refrigerant system performance test. See: Testing and Inspection/Component Tests and General Diagnostics/Refrigerant System
Performance Test
Refrigerant Pressure Sensor Installation Note
1. Apply compressor oil to O-ring and connect the joint.
