CX-7 FWD L4-2.3L Turbo (2010)
Hazard Warning Switch: Service and Repair
HAZARD WARNING SWITCH REMOVAL/INSTALLATION
CAUTION:
-
The hazard warning switch cannot be reused because it is removed by prying out the connection part of the hazard warning switch panel and
hazard warning switch. Do not remove the hazard warning switch except when replacing it.
Removal
1. Disconnect the negative battery cable.
2. Remove the following parts:
a. Decoration panel See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and Repair/Removal and
Replacement/Decoration Panel Removal/Installation
b. Center panel See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and Repair/Removal and
Replacement/Center Panel Removal/Installation
c. Audio unit See: Accessories and Optional Equipment/Radio, Stereo, and Compact Disc/Service and Repair/Removal and Replacement/Audio
Unit Removal/Installation
3. Remove the screws.
4. Disconnect the connector.
5. Turn the hazard warning switch off.
NOTE:
-
Turning off the hazard warning switch provides better visibility of the connection area between the hazard warning switch and the hazard warning
switch panel.
6. Insert a tape-wrapped flathead screwdriver in the position shown in the figure, lift it up in the direction of the arrow and shift the tab.
7. Pull out the hazard warning switch in the direction of the arrow shown in the figure.