CX-7 FWD L4-2.3L Turbo (2010)
Catalytic Converter: Testing and Inspection
WARM-UP THREE-WAY CATALYTIC CONVERTER (WU-TWC) INSPECTION [L3 WITH TC]
CAUTION:
-
Perform the following procedures, DTC P0421 is indicated only.
1. Connect the M-MDS to the DLC-2.
2. Start the engine and warm it up to normal operating temperature.
3. Turn off the engine.
4. Verify that the engine compression is within the specification. See: Tune-up and Engine Performance Checks/Compression Check/Testing and
Inspection
-
If the compression pressure is not within the specification, repair or replace the malfunction part.
5. Drive the vehicle for 10 min at65-96 km/h {40-60 mph} to allow the WU-TWC to reach operating
6. Stop the vehicle and leave it in a safe space.
7. Access Test ID 10:21:80 on the "Diagnostic Monitoring Test Result" function.
8. Verify that the test result is within the specified indicated on the M-MDS.
-
If it is not as specified, replace the WU-TWC. (See See: Engine, Cooling and Exhaust/Exhaust System/Service and Repair.)
