CX-7 FWD L4-2.3L Turbo (2010)
4. Lightly pull and push the quick release connector a few times by hand, and then verify that it can move 2.0-3.0 mm {0.08-0.12 in} and is
connected securely.
5. Inspect all related parts by performing "AFTER SERVICE PRECAUTION". (See See: Service Precautions/Vehicle Damage Warnings/After
Service Precaution.)
Type B Installation
NOTE:
-
If the quick release connector O-ring is damaged or has slipped, replace the fuel hose.
-
A checker tab is integrated with the quick release connector for new fuel hoses and evaporative hoses. Remove the checker tab from the quick
release connector after the connector is completely engaged with the fuel pipe.
CAUTION:
-
Be sure to replace the retainer with a new one to prevent gas leakage.
-
To prevent evaporative gas leakage, be sure not to damage the connecting part between the charcoal canister and pipe, and the locks between the
quick release connector and retainer. If any of them are damaged, replace the charcoal canister or hose with a new one.
1. Remove the retainer remaining on the charcoal canister pipe.
2. Install a new retainer to the quick release connector.
3. Reconnect the hose straight to the pipe until a click is heard.
4. Lightly pull and push the quick release connector a few times by hand, and then verify that it is connected securely.
5. Inspect all related parts by performing "AFTER SERVICE PRECAUTION". (See See: Service Precautions/Vehicle Damage Warnings/After
Service Precaution.)
Type C Installation
NOTE:
-
If the quick release connector O-ring is damaged or has slipped, replace the fuel hose.
1. Inspect the fuel hose and fuel pipe sealing surface for damage and deformation.
-
If there is any malfunction, replace it with a new one.
2. Install the quick release connector.
-
Insert the fuel pipe straight to the end of the quick release connector.
-
Push down the retainer using a finger.
-
If the retainer cannot be pushed down, push the fuel pipe further to the quick release connector.
3. Lightly pull and push the quick release connector a few times by hand, and then verify that it is connected securely.
4. Inspect all related parts by performing "AFTER SERVICE PRECAUTION". (See See: Service Precautions/Vehicle Damage Warnings/After
