CX-7 FWD L4-2.3L Turbo (2010)
-
If there is any malfunction, inspect the coupler component for continuity.
If coupler component has no malfunction, perform the "Off-vehicle inspection".
Solenoid valve specification
Operating inspection
CAUTION:
-
Do not apply battery position voltage to terminals for more than 3 s.
NOTE:
-
Because the operation sound of the solenoid valve is small, perform inspection in a quiet place.
1. Disconnect the coupler component connector.
a. Disconnect the negative battery cable.
b. Disconnect the coupler component connector.
2. Apply battery positive voltage to the coupler component terminals A, B and battery negative voltage to GND, and verify that operating sound is
heard from solenoid valve.
-
If the operation sound is not heard, inspect the coupler component for continuity.
If coupler component has no malfunction, perform the "Off-vehicle inspection".
Off-Vehicle inspection
1. Measure the resistance between the coupler component terminals.
-
If there is any malfunction, replace the solenoid valve. See: Service and Repair
Pressure control solenoid B specification
-
1.0-4.2 ohms