CX-7 FWD L4-2.3L Turbo (2010)
Transmission Speed Sensor: Testing and Inspection
Vehicle Speed Sensor (VSS) Inspection - FS5A-EL
VEHICLE SPEED SENSOR (VSS) INSPECTION [FS5A-EL]
On-Vehicle Inspection
1. Inspect the power supply circuit for the VSS.
a. Remove the under cover.
b. Disconnect the VSS connector.
c. Turn the ignition switch to the ON position.
d. Measure the voltage at VSS connector terminal A (harness-side).
-
If there is any malfunction, repair wiring harness between VSS and TCM.
VSS specification
-
4.5-5.5 V
e. Turn the ignition switch off.
f.
Connect the VSS connector.
2. Inspect the GND circuit for the VSS.
a. Turn the ignition switch off.
b. Measure the voltage at VSS sensor connector terminal C (harness-side).
-
If there is any malfunction, repair wiring harness between VSS sensor and TCM.
VSS sensor specification
-
Below 1.0 V
