CX-7 FWD L4-2.3L Turbo (2010)
Keyless Entry Module: Service and Repair
Keyless Control Module Removal/Installation - Advanced Keyless Entry and Start System
KEYLESS CONTROL MODULE REMOVAL/INSTALLATION [ADVANCED KEYLESS ENTRY AND START SYSTEM]
1. If the keyless control module is replaced, always perform the following procedure.
-
Keyless Control Module Configuration See: Testing and Inspection/Programming and Relearning/Keyless Control Module Configuration
-
Immobilizer System-related Parts Programming [No.6 Programming Procedure Due to Keyless Control Module Replacement] See:
Accessories and Optional Equipment/Antitheft and Alarm Systems/Testing and Inspection/Programming and Relearning/Immobilizer
System-Related Parts Programming (Advanced Keyless Entry and Start System)
2. Disconnect the negative battery cable.
3. Remove the front side trim. See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair/Front Side Trim Removal/Installation
4. Disconnect the keyless control module connector.
5. Remove the bolt, then remove the keyless control module.
6. Install in the reverse order of removal.
