CX-7 FWD L4-2.3L Turbo (2010)
-
When using the IDS (laptop PC)
1
Select the "Module Programming".
3. Then, select items from the screen menu in the following order.
1
Select "Programmable Module Installation".
2
Select "RKE".
4. Perform the configuration according to the directions on the screen.
5. Retrieve DTCs by the M-MDS, then verify that there is no DTC present.
-
If a DTC (s) is detected, perform the applicable DTC inspection. See: Accessories and Optional Equipment/Antitheft and Alarm
Systems/Keyless Entry/Testing and Inspection/Reading and Clearing Diagnostic Trouble Codes/DTC Inspection - Advanced Keyless Entry
and Start System
Steering Lock Unit ID Code Registration
STEERING LOCK UNIT ID CODE REGISTRATION [ADVANCED KEYLESS ENTRY AND START SYSTEM]
CAUTION:
-
Do not place the following devices in the vehicle while programming, otherwise programming cannot be performed:
-
M-MDS
-
Personal computer
-
Devices that can send/receive radio waves
NOTE:
-
The steering lock unit and steering lock component are a single unit. Therefore, replace the steering lock component when replacing steering lock
unit. (See See: Steering and Suspension/Steering/Steering Column/Service and Repair)
-
For this procedure, a programmed card key is necessary. If there is no programmed card key, perform the steering lock unit programming after the
card key programming.
1. Bring the programmed advanced key into the vehicle.
2. Fully lower the driver-side door glass.
3. Connect the M-MDS to the DLC-2.
4. Pull out the M-MDS cable from the door glass opening and set the M-MDS outside the vehicle.
CAUTION:
-
Cover the vehicle body with a clean rag so as not to damage the vehicle body with the cable.
5. After the vehicle is identified, select the following items from the initialization screen of the M-MDS.
-
When using the IDS (laptop PC)
-
Select "Body".
-
Select "Security".
-
Select "PATS Functions".
-
When using the PDS (Pocket PC)
-
Select "All Tests and Calibrations".