CX-7 FWD L4-2.3L Turbo (2010)
Seat Belt Height Adjuster: Service and Repair
ADJUSTER ANCHOR REMOVAL/INSTALLATION
WARNING:
-
The side air bag sensor is attached to the lower part of the B-pillar. When working around the B-pillar, disconnect the negative battery cable or
work carefully, avoiding excessive impact to the lower part of the B-pillar.
1. Turn the ignition switch to the LOCK position.
2. Disconnect the negative battery cable.
3. Remove the following parts:
a. Front seat belt upper anchor installation bolt See: Seat Belt/Service and Repair/Front Seat Belt Removal/Installation
b. Front scuff plate inner See: Body and Frame/Interior Moulding / Trim/Scuff Plate/Service and Repair/Front Scuff Plate Removal/Installation
c. Rear scuff plate inner See: Body and Frame/Interior Moulding / Trim/Scuff Plate/Service and Repair/Rear Scuff Plate Removal/Installation
d. B-pillar lower trim See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair/B-Pillar Lower Trim Removal/Installation
e. B-pillar upper trim See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair/B-Pillar Upper Trim Removal/Installation
4. Remove in the order indicated in the table.
5. Install in the reverse order of removal.
