CX-7 FWD L4-2.3L Turbo (2010)
Trailing Arm: Service and Repair
REAR TRAILING LINK REMOVAL/INSTALLATION [2WD]
CAUTION:
-
Performing the following procedures without first removing the ABS wheel-speed sensor may possibly cause an open circuit in the harness if it is
pulled by mistake. Before performing the following procedures, remove the ABS wheel-speed sensor (axle side) and fix it to an appropriate place
where the sensor will not be pulled by mistake while servicing the vehicle.
1. Remove the middle pipe. See: Engine, Cooling and Exhaust/Exhaust System/Service and Repair See: Engine, Cooling and Exhaust/Exhaust
System/Service and Repair
2. Remove the rear stabilizer. See: Stabilizer Bar/Service and Repair/Rear Stabilizer Removal/Installation
3. Remove the rear coil spring. See: Suspension Spring ( Coil / Leaf )/Service and Repair/Removal and Replacement/Rear Suspension
4. Remove in the order indicated in the table.
5. Install in the reverse order of removal.
6. Inspect the rear wheel alignment. See: Alignment/Service and Repair/Rear Wheel Alignment
