CX-7 FWD L4-2.3L Turbo (2010)
Tire Pressure Sensor: Service and Repair
WHEEL UNIT REMOVAL/INSTALLATION
1. Remove in the order indicated in the table.
2. Install in the reverse order of removal.
3. When replacing wheel unit (s), register the new wheel unit ID (s). See: Testing and Inspection/Programming and Relearning
NOTE:
-
If the wheel unit is replaced with a new one, the ID registration must be performed. When the ID registration is finished, the data for the new
wheel unit is displayed on the M-MDS.
Valve Core Removal Note
1. Remove the valve core of the wheel unit, and bleed the air from the tire.
Wheel Unit Removal Note
1. Push the tire valve completely into the tire.
CAUTION:
-
Breaking the tire bead with the wheel unit installed normally could damage the unit. Be sure to always push the wheel unit so that it is
completely inside the tire to prevent any damage.
2. Position the shoe (bead breaker) of the tire changer 10-20 mm {0.40-0.78 in} from the outer edge of the wheel, and break both tire beads.
